![background image](http://html.mh-extra.com/html/xerox/workcentre-5335-series/workcentre-5335-series_service-manual_884308071.webp)
BUS Updated 12/2011
07/2011
2-55
WorkCentre 5335 Family Service Documentation
003-966, 003-967
Status Indicator RAPs
Initial Issue
003-966 ATS/APS Destination (IIT) RAP
ATS/APS No Destination Error. ATS/APS NG (Other than No Paper) (IIT). The correct size is
not loaded for APS operation.
Procedure
•
Select a tray that supplies the required size paper and repeat the operation. Turn the
power OFF then ON. If the problem persists, replace the tray module.
•
Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firmware
module, EEPROM)
•
Check the sw version of the controller sw - reload Software (
GP 16
)
003-967 DADF APS No Destination RAP
•
Document size with DADF 8.5×11SEF Document size input not included.
•
Mix Size is not selected.
•
Magnification is variable.
•
APS Copy job with the above is designated but the tray to be selected is not available.
Although A4SEF original is set, it is detected as 8.5×11SEF
Procedure
1.
Load tray with the paper of the size displayed on the Panel or select the tray in which the
paper requested is loaded.
2.
If A4SEF document is detected as Letter document, cancel the job and then readjust
DADF document guide securely until they touches the edges of the documents. Re-run
the job.
3.
Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firmware
module, EEPROM)
4.
Check the sw version of the controller sw - reload Software (
GP 16
)