![background image](http://html.mh-extra.com/html/xerox/workcentre-5335-series/workcentre-5335-series_service-manual_884308423.webp)
BUS Updated 12/2011
07/2011
2-414
WorkCentre 5335 Family Service Documentation
024-943, 024-946
Initial Issue
Status Indicator RAPs
024-943 Booklet Low Staple RAP
BSD-ON:
BSD 12.26 - Office Finisher Booklet Staple Control (1 of 2 - Front)
BSD-ON:
BSD 12.27 - Office Finisher Booklet Staple Control (2 of 2 - Rear)
Booklet Low Staple. There are few remaining staples for booklets. (This fault can also occur if
the cartridge is removed.)
Procedure
•
Replace the Staple Cartridge. If the problem persists, go to the
012-249
LX or
012-268
LX
RAPs.
•
Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firmware
module, EEPROM)
•
Check the sw version of the controller sw - update if required
024-946 Tray 1 Position RAP
BSD-ON:
BSD 7.1 - Tray 1 Paper Size Sensing
The Tray 1 Paper Size Switch detected no tray.
Initial Actions
•
Switch the power off, then on.
•
Pull out and re-insert Tray 1.
Procedure
Check the following:
•
Broken link and breakage at the bottom of the tray
•
The Actuator at the rear of the Tray for operation failure
•
The Tray 1 Paper Size Switch for failure:
Analog Monitor
[071-200];
Component Control
[071-104] (
PL 9.1
)
•
The connection between the Tray 1 Paper Size Sensor
P/J122
and the MCU PWB
P/
J414
for open circuit, short circuit, and poor contact
Reload the machine software (
GP 16
). If no problems are found, replace the MCU PWB (
PL
18.2
).