![background image](http://html.mh-extra.com/html/xerox/workcentre-5335-series/workcentre-5335-series_service-manual_8843081254.webp)
BUS Updated 12/2011
07/2011
4-198
WorkCentre 5335 Family Service Documentation
ADJ 6.2
Initial Issue
Repairs & Adjustments
ADJ 6.2 Full/Half Rate Carriage Position Adjustment
Parts List on
PL 1.3
Purpose
Adjust the position of the Full/Half Rate Carriage.
Adjustment
1.
Press the Job Status button to check that there are no jobs in progress.
2.
Switch off the power and disconnect the power cord
3.
Open DADF or the Platen Cover.
4.
Remove the Platen Glass (
REP 6.2
)
5.
Remove the Lens Cover Assembly (
PL 18.4
)
6.
Remove the alignment pins from the Lens Assembly (
Figure 1
):
NOTE: When removing the alignment pins, never remove the screws (x4) that secure the
Lens Base.
(1) - Remove the screws (x2).
(2) - Remove the alignment pins (x2).
Figure 1 Remove the Alignment Pins
7.
Align the alignment pin holes in the Half Rate Carriage with the holes in the rail (
Figure 2
).
Figure 2 Aligning the Half Rate Carriage 1/3
8.
Install the alignment pin to the Half Rate Carriage. (
Figure 3
)
NOTE: Install the alignment pins near the edges (the front tool to the front and the rear
tool to the rear). The illustrations show only the rear.
(1) - Position the alignment pins. (Front/Rear)
(2) - Secure with a screw.