![background image](http://html.mh-extra.com/html/xerox/workcentre-5335-series/workcentre-5335-series_service-manual_8843081440.webp)
BUS Updated 12/2011
07/2011
6-45
WorkCentre 5335 Family Service Documentation
GP 11
General Procedures & Information
Initial Issue
Figure 2 ESS PWB Connection
c.
The Foreign Accessory connects to
P2
on the FDI.
d.
Switch on the power.
3.
Go to
NVM Read/Write
. Set the locations in
Table 1
depending on the type of device and
the customer’s wishes:
J351
Table 1 FDI NVM Settings
NVM loc.
Name
Function
Values
850-001
FDI Connection
FDI is present. Automatically recognized only when FDI is connected upon
M/C power on.
Disabling FDI-CRD function, must enter [0], turn off MC and remove the
FDI connection.
0 = disabled (default)
1 = enabled
850-007
Accessory Type
Type of Cost Recovery Device connected.
This function is for UI Message.
Disabling FDI-CRD function, must enter [0], turn off MC and remove the
FDI connection.
0 = None or Foot Switch (default)
1 = Additive Mode (UI msg = Use a Valid Card)
2 = Subtractive Mode (UI msg = Use a Valid Card)
3 = Dispenser - Subtractive Mode (UI msg = Use a Valid Card)
4 = Coin-Op Kit - Subtractive Mode (UI msg = Insert Coins)
5 = Multiple connection of CopyLyzer & Dispenser - Subtractive Mode
(UI msg = Use a Valid Card)
6 = Multiple connection of CopyLyzer & Coin-Op Kit - Subtractive
Mode (UI msg = Insert Coins or Use a Valid Card)
7 = Multiple connection of Dispenser & Coin-Op Kit - Subtractive
Mode (UI msg = Insert Coins or Use a Valid Card)
850-009
Print Job Control
Disable / Enable controlling charge print jobs by FDI-CRD
0 = disabled (default)
1 = enabled
850-010
Interrupt Function
Disable / Enable the function of Interrupt at Subtractive CRD configuration. 0 = disabled (default)
1 = enabled
NOTE: When NVM 850-016 is set to 2, this setting is prohibited to be
set to enable Interrupt.