![background image](http://html.mh-extra.com/html/xerox/workcentre-5335-series/workcentre-5335-series_service-manual_884308800.webp)
BUS Updated 12/2011
07/2011
2-800
WorkCentre 5335 Family Service Documentation
074-212, 074-900
Initial Issue
Status Indicator RAPs
074-212 Tray 4 Paper Size Sensor Broken RAP
BSD-ON:
BSD 7.4 - Tray 4 Paper Size Sensing (TTM)
Abnormal output AD value from Tray 4 Size Sensor was detected.
NOTE: When turning the power OFF, turn OFF the power switch first and then the main power
switch.
Procedure
Check the following:
•
Broken link and breakage at the bottom of the tray
•
The Actuator at the rear of the Tray for operation failure
•
The Tray 4 Paper Size Switch for failure:
Analog Monitor
[074-200];
Component Control
[074-104] (
PL 11.12
)
•
The connection between the Tray 4 Paper Size Sensor
P/J103
and the Tray Module
PWB
P/J548
for open circuit, short circuit, and poor contact
Reload the machine software (
GP 16
). If no problems are found, replace the Tray Module PWB
(
PL 11.13
).
074-900 Tray 4 Feed Out Sensor Static Jam RAP
BSD-ON:
BSD 8.3 - Paper Transportation (Tandem Tray Module)
When the power was turned ON, the M/C was stopped (Cycle Down/ Shut Down), or when the
interlocks were closed (all interlocks including options), the Tray 4 Feed Out Sensor detected
paper.
NOTE: When turning the power OFF, turn OFF the power switch first and then the main power
switch.
Procedure
Check the following:
•
The Tray 4 Feed Out Sensor (
PL 11.7
) for remaining paper, contamination, Actuator
return failure, or improper installation
•
The Tray 4 Feed Out Sensor for failure:
Component Control
[073-100] (
PL 11.7
)
•
The connection between the Tray 4 Feed Out Sensor
P/J116
-2 and the Tray Module
PWB
P/J548
-A2 for short circuit
Reload the machine software (
GP 16
). If no problems are found, replace the Tray Module PWB
(
PL 11.13
).