![background image](http://html.mh-extra.com/html/xerox/workcentre-5335-series/workcentre-5335-series_service-manual_884308127.webp)
BUS Updated 12/2011
07/2011
2-113
WorkCentre 5335 Family Service Documentation
012-221, 012-223
Status Indicator RAPs
Initial Issue
Y
N
Repair/reconnect as required.
Replace the front Tamper Motor (
PL 23.12
). If the problem persists, replace the Finisher
PWB (
PL 23.16
).
Replace the Finisher PWB (
PL 23.16
).
012-223 Front Tamper Home Sensor Off Failure RAP (LX)
BSD-ON:
BSD 12.18 - Office Finisher LX Tamping & Offset (1 of 2)
BSD-ON:
BSD 12.19 - Office Finisher LX Tamping & Offset (2 of 2)
BSD-ON:
BSD 12.12 - Office Finisher LX Interlock Switching
After the Front Tamper started moving away from the home position, the Front Tamper Home
Sensor did not turn Off within the specified time.
Procedure
Manually operate the Tamper mechanism. The Tamper mechanism moves smoothly.
Y
N
Replace the parts that are interfering with operation.
Execute
Component Control
[012-220], Front Tamper Home Sensor. Manually operate the
Tamper mechanism to block and unblock the sensor. The display changes.
Y
N
Check the wire between
J8881
pin 2 and
P/J8994
pin 5 for an open or short circuit, or a
loose or damaged connector. The wire is OK.
Y
N
Repair/reconnect as required.
Measure the voltage between
P/J8994
, pins 6 and 4 on the Finisher PWB
BSD 12.18 -
Office Finisher LX Tamping & Offset (1 of 2)
. The voltage is approx. +5VDC.
Y
N
Replace the Finisher PWB (
PL 23.16
).
Measure the voltage between
P/J8994
, pin 5 on the Finisher PWB and GND (
BSD 12.18
- Office Finisher LX Tamping & Offset (1 of 2)
. Manually operate the Tamper mecha-
nism to block and unblock the Front Tamper Home Sensor. The voltage changes.
Y
N
Replace the Front Tamper Home Sensor (
PL 23.12
).
Replace the Finisher PWB (
PL 23.16
).
Alternately execute
Component Control
[012-020], Front Tamper Motor Front and [012-023],
Front Tamper Motor Rear. The Front Tamper Motor moves.
Y
N
There is +24 VDC from
P/J8994
pin 19 on the Finisher PWB to GND
Y
N
There is +24 VDC from
J8982
pin 4 on the Finisher PWB to GND
Y
N
Go to
BSD 12.12 - Office Finisher LX Interlock Switching
:
J8982
and check
the +24V circuit feeding pin 4. Repair/reconnect as required.
Replace the Finisher PWB (
PL 23.16
).
Check the wires between
P/J8994
, pins 18 ~ 22 on the Finisher PWB, and the Front
Tamper Motor
P/J8884
for an open or short circuit, or a loose or damaged connector.
The wires are OK.
A
A