![background image](http://html.mh-extra.com/html/xerox/workcentre-5335-series/workcentre-5335-series_service-manual_884308064.webp)
BUS Updated 12/2011
07/2011
2-48
WorkCentre 5335 Family Service Documentation
003-935, 003-940
Initial Issue
Status Indicator RAPs
003-935 600 DPI Scan RAP
BSD-ON:
BSD 3.5 - ESS-DADF Communication
When scanning in the DADF mix duplex mode, 600dpi is not available (when the next docu-
ment exists). Because Page Memory is insufficient, a selected resolution is not available for
scanning an A3 document. It is available for scanning an A4/B4 document.
Procedure
•
Verify scan settings (at below 600dpi) are correctly set and menu selections are correctly
set. Increase Page Memory (
PL 35.2
).
•
Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firmware
module, EEPROM)
•
Check the sw version of the controller sw - reload Software (
GP 16
)
003-940 Memory RAP
Insufficient Page Memory detected.
When IITsc is activated for the jobs that meet the following AND conditions:
•
Page Memory < 384MB (
PL 35.2
)
•
Side 2 cover image is selected
•
Color mode is not set to Black/White
•
High Quality mode
Procedure
•
Power Off/On.
•
Cancel the job. Clear the B/W setting for Color mode or the Side 2 cover image setting,
and execute the job again.
•
Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firmware
module, EEPROM)
•
Check the sw version of the controller sw - reload Software (
GP 16
)
•
If the problem persists replace the IIT PWB (Switch the EEPROM) (
PL 1.6
).