BUS Updated 12/2011
07/2011
2-417
WorkCentre 5335 Family Service Documentation
024-951, 024-952
Status Indicator RAPs
Initial Issue
024-951 Tray 2 No Paper RAP
BSD-ON:
BSD 7.6 - Tray 2 Paper Stacking
Tray 2 is out of paper.
Initial Actions
•
Power Off/On
Procedure
Check the installation of the Tray 2 No Paper Sensor (
PL 9.4
) and the operation of the actua-
tor. The Sensor is installed correctly and the actuator works.
Y
N
Reinstall the Sensor.
Execute
Component Control
[072-101], Tray 2 No Paper Sensor. Manually activate the Tray 2
No Paper Sensor. The display changes.
Y
N
Go to
BSD 7.6 - Tray 2 Paper Stacking
. Troubleshoot the circuit of the Tray 2 No Paper
Sensor (
PL 9.5
). Refer to the
OF 99-2
, Transmissive Sensor RAP.
Go to the
072-210
RAP to check the Tray 2 Feed LIft Motor.
•
Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firmware
module, EEPROM)
•
Check the sw version of the controller sw - update if required (
GP 16
)
024-952 Tray 3 No Paper RAP
BSD-ON:
BSD 7.7 - Tray 3 Paper Stacking (TTM)
Tray 3 is out of paper.
Initial Actions
•
Power Off/On
Procedure
Check the installation of the Tray 3 No Paper Sensor (
PL 10.4
) and the operation of the actua-
tor. The Sensor is installed correctly and the actuator works.
Y
N
Reinstall the Sensor.
Execute
Component Control
[073-101], Tray 3 No Paper Sensor. Manually activate the Tray 3
No Paper Sensor (
PL 11.8
). The display changes.
Y
N
Go to
BSD 7.7 - Tray 3 Paper Stacking (TTM)
Troubleshoot the circuit of the Tray 3 Tray
Empty Sensor. Refer to the
OF 99-2
, Transmissive Sensor RAP.
Go to the
073-210
RAP to check the Tray 3 Feed LIft Motor.
•
Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firmware
module, EEPROM)
•
Check the sw version of the controller sw - update if required (
GP 16
)