![background image](http://html.mh-extra.com/html/xerox/workcentre-5335-series/workcentre-5335-series_service-manual_884308140.webp)
BUS Updated 12/2011
07/2011
2-126
WorkCentre 5335 Family Service Documentation
012-302 , 012-303
Initial Issue
Status Indicator RAPs
012-302 Finisher Front Cover Open RAP (LX)
BSD-ON:
BSD 12.12 - Office Finisher LX Interlock Switching
The Finisher Front Cover is open.
Initial Actions
•
Check the installation of the H-Transport Open Sensor
•
Opening/closing of the Finisher H-Transport Cover.
Procedure
Execute
Component Control
[012-302], Front Door Interlock Switch. Open/close the Finisher
Front Cover. The display changes.
Y
N
Open the Front Door and cheat the Front Door Interlock Switch The display changes.
Y
N
Check the wires between
J8982
pin 3 and
J8891
pin 2B, and from
J8891
pin 2A to
J8982
pin 2 for an open or short circuit, or a loose or damaged connector. The
wires are OK.
Y
N
Repair/reconnect as required.
Remove the cheater. Measure the voltage between
J8891
pin 2A on the Front Door
Interlock Switch and GND (
BSD 12.12 - Office Finisher LX Interlock Switching
).
The voltage is approx. +5VDC.
Y
N
Check the wire from
J8891
pin 2A to
J8982
pin 3 for an open or short circuit,
or a loose or damaged connector. If the wires are OK, replace the Finisher
PWB (
PL 23.16
).
Cheat the Interlock Switch. The voltage drops to 0 VDC.
Y
N
Replace the Front Door Interlock Switch (
PL 23.16
).
Replace the Finisher PWB (
PL 23.16
).
Check the actuator for damage or misalignment
Check the Interlock circuit for an intermittent condition
BSD 12.12 - Office Finisher LX Inter-
lock Switching
If the problem continues, replace the Finisher PWB (
PL 23.16
).
012-303 Finisher H-Transport Cover Open RAP (LX)
BSD-ON:
BSD 12.14 - Office Finisher LX Horizontal Transportation
The Finisher H-Transport Cover is open.
Initial Actions
•
Check the installation of the H-Transport Open Sensor
•
Opening/closing of the Finisher H-Transport Cover.
Procedure
Execute
Component Control
[012-303], H-Transport Open Sensor. Actuate the H-Transport
Open Sensor (
PL 23.4
). The display changes.
Y
N
Check the wire between
J8860
pin 2 and
J8897
pin 2 for an open or short circuit, or a
loose or damaged connector. The wire is OK.
Y
N
Repair/reconnect as required.
Measure the voltage between
J8897
, pins 3 and 1 on the Finisher PWB (
BSD 12.14 -
Office Finisher LX Horizontal Transportation
. The voltage is approx. +5VDC.
Y
N
Replace the Finisher PWB (
PL 23.16
).
Measure the voltage between
J8897
, pin 2 on the Finisher PWB and GND (
BSD 12.14 -
Office Finisher LX Horizontal Transportation
). Actuate the H-Transport Open Sensor.
The voltage changes.
Y
N
Replace the H-Transport Open Sensor (
PL 23.4
).
Replace the Finisher PWB (
PL 23.16
).
If the problem continues, replace the Finisher PWB (
PL 23.16
).