![background image](http://html.mh-extra.com/html/xerox/workcentre-5335-series/workcentre-5335-series_service-manual_884308251.webp)
BUS Updated 12/2011
07/2011
2-238
WorkCentre 5335 Family Service Documentation
016-718, 016-719
Initial Issue
Status Indicator RAPs
016-718 PCL6 Memory RAP
Insufficient PCL6 Decomposer Memory
Procedure
•
As the PLW memory is fixed, decreasing the resolution may reduce the PLW memory.
(Only when PLW is enabled)
•
Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firmware
module, EEPROM)
•
Check the sw version of the controller sw - update if required
016-719 Out of PCL Memory RAP
Insufficient memory is detected while using PCL.
Initial Actions
Power Off/On
Procedure
•
Increase the PCL memory size. Increasing the memory for the whole system will increase
the memory to be allocated to the Decomposer in some measure.
•
UI settings or other ways cannot explicitly increase the PCL memory.
•
Therefore, if a job is aborted due to insufficient memory when the memory has been
increased to the maximum capacity, change the printer driver settings to see if printing
becomes available.
•
If the problem persists, perform the following procedure to repair it.
–
Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firm-
ware module, EEPROM)
–
Check the sw version of the controller sw - update if required