![background image](http://html.mh-extra.com/html/xerox/workcentre-5335-series/workcentre-5335-series_service-manual_884308791.webp)
BUS Updated 12/2011
07/2011
2-789
WorkCentre 5335 Family Service Documentation
072-100, 072-101
Status Indicator RAPs
Initial Issue
072-100Tray 2 Pre Misfeed RAP
BSD-ON:
BSD 7.6 - Tray 2 Paper Stacking
BSD-ON:
BSD 8.2 - IOT Paper Transportation
Tray2 Pre Feed Sensor is not turned ON by the paper in specified time from Tray 2 Feed Start.
Initial Actions
•
A paper transportation failure due to a foreign substance/burr on the paper path
•
The Tray 2 Feed Roll, Retard Roll, and Nudger Roll for contamination, wear, and revolu-
tion failure (when the jam has occurred during Feed from Tray 2)
•
Use of paper out of spec
•
The Tray 2 Pre Feed Sensor for contamination, improper installation, and Actuator opera-
tion failure
Procedure
Check the following:
•
The Tray 2 Pre Feed Sensor for failure:
Component Control
[072-105] (
PL 9.5
)
•
The Tray 2 Feed/Lift Motor failure:
Component Control
[072-003] CW (
PL 9.6
)
•
The connection between the Tray 2 Pre Feed Sensor
P/J107
and the MCU PWB
P/J410
for open circuit, short circuit, and poor contact
Reload the machine software (
GP 16
). If no problems are found, replace the MCU PWB (
PL
18.2
).
072-101Tray 2 Misfeed RAP
BSD-ON:
BSD 7.6 - Tray 2 Paper Stacking
BSD-ON:
BSD 8.2 - IOT Paper Transportation
The Tray 2 Feed Out Sensor does not turn ON within the specified time after the Feed from
Tray 2 has started.
Initial Actions
•
A paper transportation failure due to a foreign substance/burr on the paper path
•
The Feed Out Sensor for contamination, improper installation, and Actuator operation fail-
ure
•
The Tray 2 Feed Roll, Retard Roll, and Nudger Roll for contamination, wear, and revolu-
tion failure (when the jam has occurred during Feed from Tray 2)
•
The Takeaway Roll 2 and Pinch Roll for contamination, wear, and revolution failure
•
The Takeaway Roll 2 Drive Gear for wear and damage
•
The Feed Roll, Retard Roll, and Nudger Roll Drive Gears for wear and damage
•
Use of paper out of spec
Procedure
Check the following:
•
The Feed Out Sensor for failure:
Component Control
[072-100] (
PL 9.5
)
•
Takeaway Motor failure:
Component Control
[077-050] CW (
PL 15.1
)
•
The connection between the Feed Out Sensor
P/J110
and the MCU PWB
P/J410
for
open circuit, short circuit, and poor contact
Reload the machine software (
GP 16
). If no problems are found, replace the MCU PWB (
PL
18.2
).