BUS Updated 12/2011
07/2011
2-884
WorkCentre 5335 Family Service Documentation
116-391, 116-392
Initial Issue
Status Indicator RAPs
116-391 Country Code RAP
An illegal country code is set.
When the machine is turned on and started (or also rebooted), nation info, territory code
and paper size group kept in SEEP-ROM are checked. As a result, an undefined code is
detected regarding one(s) of those pieces of information.
However, when it is turned on and started (or also rebooted) in the following way, the
machine starts successfully without checking for an error.
–
Special Boot (Power Saver+Clear All+Power ON)
Procedure
Perform
GP 15
Country Code Setting.
Turn OFF then ON the power. If the problem persists, perform the following:
1.
Enter the correct nation code, territory code and paper size group in SEEP-ROM.
* CL No.
700-165=nation code
700-338=territory code
700-402=paper size group
For correct data, see System Data List.
2.
After entering the correct values in SEEP-ROM, be sure to initialize NVMs (Sys-Sys-
tem).
If NVMs (Sys-System) are not initialized, NVN values generated based on wrong
data in SEEP-ROM will not be updated to be the correct values.
116-392 ROM DIMM Machine Code Check Fail RAP
BSD-ON:
BSD 16.1 - ESS
BSD-ON:
BSD 34.1 - FAX
ROM DIMM machine code check fail
The machine code that is stored in the EEPROM of the ESS ROM, which is inserted in SLOT1
or SLOT2, does not match the machine code that is stored in the EEPROM on the ESS PWB
(
PL 35.2
).
Initial Actions
Check the machine codes for both SLOT1 and SLOT2. If even one of them does not match,
this Fault will occur.
Procedure
NOTE: Although the correct way is to insert ESS ROM for Netware into SLOT1 and the ESS
ROM for Printer Kit into SLOT2, the machine will not display this Fault Code even if they are
inserted wrongly as long as the machine codes are matched.
Insert the Printer Kit or the PS Kit and Emulation Kit that is specified for this machine into
their specified slots on the ESS PWB (
PL 35.2
).
The correct way is to insert the ESS ROM for Netware into SLOT1 and the ESS ROM for
Printer Kit into SLOT2.
However, if the problem persists even when the Printer Kit or the PS Kit and Emulation Kit
that is specified for this machine has been inserted into their specified slots, either replace
the Kits or the ESS PWB (
PL 35.2
).