Renesas Hitachi H8S/2191, Hardware Manual, Page: 796 / 1065

Rev. 2.0, 11/00, page 769 of 1037
28.13.8 Duty Discriminator
The duty discriminator circuit measures the period of the control signal recorded on the tape
(PB-CTL signal) and discriminates its duty cycle. In VISS or VASS detection, the duty I/O flag
is set or cleared according to the result of duty discrimination. The duty I/O flag is set to 1 when
the duty cycle of the PB-CTL signal is equal to or above 44%, and is cleared to 0 when the duty
cycle is below 43%.
In ASM detection, an ASM mark is recognized (and the duty I/O flag is cleared to 0) when the
duty cycle is equal to or above 66%. When the duty cycle is below 65%, no ASM mark is
recognized and the duty I/O flag is set to 1.
The detection direction can be switched between forward and reverse by bit 5 (FW/RV) in the
CTL mode register.
A long or short pulse can be detected by comparing the REC-CTL duty data register (RCDR2 to
RCDR5) and UP/DOWN counter. Long or short pulse is discriminated at PB-CTL signal
falling. Discrimination result is stored in bit 0 (LSP0) of the bit pattern register (BTPR). At the
same time, BTPR is shifted to the left. LSP0 indicates 0 when a short pulse is detected, and 1
when a long pulse is detected.
Set the threshold value of a long/short pulse in RCDR2 to RCDR5. See (4), Detection of the
Long/Short Pulse.
Figure 28.55 shows the duty cycle of the PB-CTL signal.