Renesas Hitachi H8S/2191, Hardware Manual, Page: 518 / 1065

Rev. 2.0, 11/00, page 491 of 1037
Yes
< End >
[1]
No
Initialization
Start reception
[2]
No
Yes
Read RDRF flag in SSR1 [4]
[5]
Clear RE bit in SCR1 to 0
Error handling
(Continued below)
[3]
Read receive data in RDR1,
and clear RDRF flag in SSR1 to 0
No
Yes
ORER=1
RDRF=1
All data received?
Read ORER flag in SSR1
< End >
Error handling
Clear ORER flag in
SSR1 to 0
Overrun error handling
[3]
SCI1 initialization:
The SI1 pin is automatically designated as
the receive data input pin.
Receive error handling:
IF a receive error occurs, read the ORER
flag in SSR1, and after performing the
appropriate error handling, clear the ORER
flag to 0. Transfer cannot be resumed if
the ORER flag is set to 1.
SCI1 status check and receive data read:
Read SSR1 and check that the RDRF flag
is set to 1, then read the receive data in
RDR1 and clear the RDRF flag to 0.
Transition of the RDRF flag from 0 to 1 can
also be identified by and RXI interrupt.
Serial reception continuation procedure:
To continue serial reception, before the
MSB (bit 7) of the current frame is received,
finish reading the RDRF flag, reading
RDR1, and clearing the RDRF flag to 0
[1]
[2][3]
[4]
Figure 23.18 Sample Serial Reception Flowchart