Renesas Hitachi H8S/2191, Hardware Manual, Page: 269 / 1065

Rev. 2.0, 11/00, page 242 of 1037
(1) Port Mode Register 1 (PMR1)
0
0
1
0
R/W
2
0
R/W
3
0
4
0
R/W
0
R/W
5
0
7
0
R/W R/W R/W R/W
6
PMR14 PMR13 PMR12 PMR11 PMR10 PMR17 PMR16 PMR15
Bit :
Initial value :
R/W :
Port mode register 1 (PMR1) controls switching of each pin function of port 1. The switching is
specified in a unit of bit.
PMR1 is an 8-bit read/write enable register. When reset, PMR1 is initialized to H'00.
Note the following items when the pin functions are switched by PMR1.
(1) If port 1 is set to an
,& input pin and ,54 to ,54 by PMR1, the pin level needs be set to
the high or low level regardless of the active mode and low power consumption mode. The
pin level must not be set to an intermediate level.
(2) When the pin functions of P16/
,& and P15/,54 to P10/,54 are switched by PMR1, they
are incorrectly recognized as edge detection according to the state of a pin signal and a
detection signal may be generated. To prevent this, perform the operation in the following
procedure.
(a) Before switching the pin functions, inhibit an interrupt enable flag from being
interrupted.
(b) After having switched the pin functions, clear the relevant interrupt request flag to 0 by a
single instruction.
(Program Example)
:
MOV.B ROL,@IENR
⋅⋅⋅⋅⋅⋅
Interrupt disabled
MOV.B R1L,@PMR1
⋅⋅⋅⋅⋅⋅
Pin function change
NOP
⋅⋅⋅⋅⋅⋅
Optional instruction
BCLR m @IRQR
⋅⋅⋅⋅⋅⋅
Applicable interrupt clear
MOV.B R1L,@IENR
⋅⋅⋅⋅⋅⋅
Interrupt enabled
:
Bit 7: P17/TMOW Pin Switching (PMR17)
PMR17 sets whether the P17/TMOW pin is used as a P17 I/O pin or a TMOW pin for the
frequency division clock output.
Bit 7
PMR17 Description
0 The P17/TMOW pin functions as a P17 I/O pin (Initial value)
1 The P17/TMOW pin functions as a TMOW output pin