NXP Semiconductors K32 L2A Series, Reference Manual, Page: 1272 / 1379

TSIx_GENCS field descriptions (continued)
Field Description
0 Do not enable the End-of-Scan DMA transfer request only. Depending on ESOR state, either Out-of-
Range or End-of-Scan can trigger a DMA transfer request and interrupt.
1 Only the End-of-Scan event can trigger a DMA transfer request. The Out-of-Range event only and
always triggers an interrupt if TSIIE is set.
49.3.2 TSI DATA Register (TSIx_DATA)
Address: 4006_2000h base + 4h offset = 4006_2004h
Bit 31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16
R
TSICH
0
DMAEN
0 0
W
SWTS
Reset
0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
Bit 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
R
TSICNT
W
Reset 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
TSIx_DATA field descriptions
Field Description
31–28
TSICH
TSICH
These bits specify current channel to be measured. In hardware trigger mode (TSI_GENCS[STM] = 1), the
scan will not start until the hardware trigger occurs. In software trigger mode (TSI_GENCS[STM] = 0), the
scan starts immediately when TSI_DATA[SWTS] bit is written by 1.
0000 Channel 0.
0001 Channel 1.
0010 Channel 2.
0011 Channel 3.
0100 Channel 4.
0101 Channel 5.
0110 Channel 6.
Table continues on the next page...
Register definition
K32 L2A Reference Manual, Rev. 2, 01/2020
1272 NXP Semiconductors