Avaya MCC1, Установка и обновления

Страница: 55 / 874

Release 9si/10si/Communication Manager 1.x to Communication Manager 2.1
Task list: R9si/10si/Communication Manager 1.x to Communication Manager 2.1
SI Installation and Upgrades 55
June 2004
Verify the upgrade
Return to Task List
1
Type status system 1 and press Return.
The System 1 Status screen appears.
2
Check these fields for the corresponding values:
— In the
SPE ALARMS
section,
MAJOR
and
MINOR alarms
= 0
— In the four
SERVICE STATE
areas, ensure that the active (and standby -- High and
Critical Reliability) side(s) read in (service).
NOTE:
High and Critical Reliability: Following the upgrade, duplicated configurations enter into
a SPE maintenance interval that lasts approximately 50 minutes. When the
Mode
fields
indicate that one side is active and the other standby, then the
SERVICE STATE
fields
should read in.
You can continue with the upgrade, however some commands will be not be available
until the maintenance interval has completed.
3
If there are alarms, take the necessary corrective actions ( display alarms ).
Return to Task List
Check link status
Return to Task List
1
Type
display communication-interface links
and press Return.
NOTE:
ISDN-PRI D-channel links no longer appear on this screen. (ISDN-PRI resides on the
network packet circuit pack.) The only way to determine if an ISDN-PRI D-Channel is up
is to use the
status signaling group
command.
2
Type status link number and press Return. Repeat this step for each type of administered link.
3
Check that DS1 trunks and BRI phones are functioning normally.
4
Type list signaling-group press Return.
5
For each signaling group, type
status signal
<
number
> and press Return.
6
Ensure that the Group State field is in-service.
7
Execute the following commands and verify that the information is correct:
— list station
— list trunk-group
— list hunt-group
— list data-module
—
list ars analysis
— For a system with Expert Agent, list agent
Return to Task List