background image

© 2017 Packet Power LLC

EG4 QS V2

Ethernet Gateway V4  

Quick Start Guide

•  Insert Ethernet cable into the network port 

and connect other end to the network. 

•  Connect the universal power supply 

provided to 5V DC jack to power the 

Gateway.

•  IMPORTANT

:

 

If either of the Network 

Status lights is not lit there is no network 

connection. A network connection must be 

established before proceeding.

• 

Navigate the menu using 

the joystick; push joystick 

to enter a selection.

E4 1.9.2 

•  Select DHCP addressing 

(default) or 

turn off DHCP if 

using a static IP address

• 

If using DHCP skip to step 5.

This guide provides a summary of how to make the changes needed to allow the Gateway to work on your Ethernet network. 

 

For more detailed instructions see www.packetpower.com/support or email [email protected]

1

4

5

2

3

• 

With DHCP turned off, enter the 

IP address, netmask and gateway 

addresses. 

• 

A temporary IP address can be 

assigned and modified once you 

have access to the Gateway.

192.168……

• 

Access the 

Gateway Console

 by entering the Gateway’s 

IP address onto a web browser. 

•  Make sure the Gateway and browser are connected to an 

accessible switch or router.

 

6

SWITCH

5V DC

TO SWITCH/ 

ROUTER

NETWORKING TAB

Modifying and Saving Values

IP ADDRESS

ACCESS GATEWAY CONSOLE

SET IP ADDRESS

NETWORK 

STATUS

Always use the Reboot or Shutdown 

function to restart the Gateway. 

Never remove power while active. 

Status 

Configure

 Reboot Shutdown

Status 

Configure

 Reboot Shutdown

• 

From the left hand menu 

select “System” and then the 

“Networking” tab.

IMPORTANT

: GATEWAY MUST BE CONNECTED TO A NETWORK TO ENABLE CONFIGURATION

Отзывы: