Avaya MCC1, Установка и обновления

Страница: 582 / 874

Install Additional Hardware
Task List: Add Multiple Announcement Circuit Packs
582 SI Installation and Upgrades
June 2004
The syntax for restoring to a TN750C circuit pack is restore announcements [ disk | removable media
[ to PCSS ]] and press Enter. Where P is the port network number (1 for PPN, and 2-4 for EPN), C is the
carrier designation (A, B, C, D, or E), and SS is the number of the slot in which the circuit pack resides
(01 to 21). When executing a restore command and there are existing announcements on the circuit pack,
the following warning message appears:
!
WARNING:
This
restore announcements
command will overwrite the existing announcements on
the specified board.
After 5 minutes (with no alterations to the announcements), the TN750C automatically copies the
announcements from the Voice RAM to the internal flash memory. The yellow LED on the front of the
TN750C flashes.
You can only save the announcement contents of 1 circuit pack to mass storage at a time. For the contents
of every circuit pack, save to separate translation cards. Label each card to match the circuit pack saved to
it.
TN750 and TN750B Announcement Circuit
Packs
NOTE:
The following save and restore procedures are only necessary for TN750 and TN750B
announcement circuit packs.
The recorded announcements in the system can be saved on the mass-storage system by typing
save
announcements spe-active/spe-standby
and pressing Enter. These commands should only be used
after business hours or when the system is operating during a low-usage period. The system takes about
40 minutes to transfer the recorded announcements from the announcement circuit pack to the mass-
storage system. During this time period, the management terminal cannot be used to administer the
system until the transfer finishes; however, all other administration terminals, if provided, are allowed to
perform administration procedures.
The recorded announcements in the system can be restored to system memory from the translation card
by entering the
restore announcements
command.
Task List: Add Multiple Announcement Circuit Packs
•
Replace a TN750 or TN750B with a TN750C or Move all Announcements from a TN750B to a
TN750C
on page 583
•
Add additional TN750C Circuit Packs on page 583
•
Add a TN2501AP Announcement Circuit Pack on page 578
•
Move a Single Announcement from one Announcement Circuit Pack to another on page 584