Rohde & Schwarz 1323.0012.03, User Manual

Page: 882 / 1014

Command Reference
R&S
®
ZNL/ZNLE
882 User Manual 1178.5966.02 ─ 07
[SENSe<Ch>:]SWEep:TIME:AUTO
..................................................................................886
[SENSe<Ch>:]SWEep:TYPE
...........................................................................................886
[SENSe<Chn>:]SWEep:SRCPort
.....................................................................................887
[SENSe:]SWEep:COUNt:ALL <Sweep>
Defines the number of sweeps to be measured in single sweep mode
(
INITiate<Ch>:CONTinuous OFF
). The setting is applied to all channels. Use
[SENSe<Ch>:]SWEep:COUNt
to define the sweep count for a single channel.
Setting parameters:
<Sweep> Number of consecutive sweeps to be measured.
Range:
1 to 100000
*RST: 1
Example: See Chapter 10.6.2.4, "Data Handling" , on page 957.
Usage: Setting only
Manual operation: See "Sweeps" on page 320
[SENSe<Ch>:]SWEep:COUNt <Sweep>
Defines the number of sweeps to be measured in single sweep mode
(
INITiate<Ch>:CONTinuous OFF
) and in channel no. <Ch>. Use
[SENSe:]SWEep:
COUNt:ALL
to define the sweep count for all channels.
Suffix:
<Ch>
.
Channel number
Parameters:
<Sweep> Number of consecutive sweeps to be measured.
Range:
1 to 100000
*RST: 1
Example: See
CALCulate<Chn>:DATA:NSWeep:FIRSt?
Manual operation: See "Sweeps" on page 320
[SENSe<Ch>:]SWEep:DWELl <MeasDelay>
Defines the "Meas. Delay" before each partial measurement or the first partial mea-
surement (see
[SENSe<Ch>:]SWEep:DWELl:IPOint
). Setting a delay disables the
automatic calculation of the (minimum) sweep time (see
[SENSe<Ch>:]SWEep:
TIME:AUTO
).
Suffix:
<Ch>
.
Channel number
VNA Command Reference
www.allice.de Allice Messtechnik GmbH