Command Reference
R&S
®
ZNL/ZNLE
730
User Manual 1178.5966.02 ─ 07
Example:
*RST; :CONF:CHAN2:STAT ON; NAME 'New Channel'
Create channel 2 and assign the channel name "New Channel".
CONF:CHAN:CAT?
Query all channels and their names. As a default channel no. 1
is created on
*RST
, the response is
'1,Ch1,2,New_Channel'
.
CONF:CHAN:NAME:ID? 'New Channel'
Query the channel number for the channel named "New Chan-
nel". The response is
2
.
Usage:
Query only
Manual operation:
CONFigure:CHANnel:MEASure:ALL[:STATe]
<Boolean>
Enables or disables the sweep in all channels of the active channel setup. This com-
mand can be used in combination with
CONFigure:CHANnel<Ch>:MEASure[:
to optimize the measurement speed.
Parameters:
<Boolean>
ON | OFF
*RST:
ON
Example:
CONFigure:CHANnel<Ch>:MEASure[:STATe]
Manual operation:
CONFigure:CHANnel<Ch>[:STATe]
<Boolean>
Creates or deletes channel no.
<Ch>
and selects it as the active channel.
defines the channel name.
A channel created with
CONFigure:CHANnel<Ch>[:STATe] ON
can be configured
but has no trace assigned so that no measurement can be initiated. Use
CALCulate<Ch>:PARameter:SDEFine
"<TraceName>,"<Parameter>"
to create
a new channel and a new trace. In remote control it is possible to remove all channels.
This is in contrast to manual control where at least one channel with one diagram area
and one trace must be available.
Suffix:
<Ch>
.
Number of the channel to be created or deleted.
Parameters:
<Boolean>
ON - create channel no.
<Ch>
. If the channel no.
<Ch>
exists
already, it is not modified but selected as the active channel.
OFF - delete channel no.
<Ch>
.
*RST:
ON for channel no. 1 (created on *RST), OFF for all
other channels.
Example:
Manual operation:
VNA Command Reference
www.allice.de
Allice Messtechnik GmbH
