Command Reference
R&S
®
ZNL/ZNLE
806
User Manual 1178.5966.02 ─ 07
For an overview of calibration methods and error terms refer to
Suffix:
<Ch>
.
Channel number of the calibrated channel.
Parameters:
<ErrorTerm>
String parameters describing the different error terms, depend-
ing on the current calibration method; see table below. Each
term contains one complex value (real and imaginary part) for
each sweep point. The parameters must be transferred in full
length. The following strings are allowed:
'DIRECTIVITY'
–
directivity at the <SourcePort>
'SRCMATCH'
–
source match at the <SourcePort>
'REFLTRACK'
–
reflection tracking at the <SourcePort>
'LOADMATCH'
–
load match at the <LoadPort>
'TRANSTRACK'
–
transmission tracking between the <Source-
Port> and the <LoadPort>; see above.
Range:
The error terms are dimensionless complex num-
bers.
*RST:
n/a
<SourcePort>
Source port number
<LoadPort>
Load port number. If the error term is not related to the load port,
a dummy number can be used; e.g.
CORR:CDAT
'REFLTRACK', 1, 0
<CorrectionData>
Correction data set (one complex number per sweep point) to be
transferred to the analyzer either in ASCII or block data format,
depending on the current
tion data set is assigned to the specified channel, error term,
source and load port.
This parameter must not be used for queries.
Example:
See
[SENSe<Ch>:]CORRection:COLLect:SAVE:
The different calibration types of the analyzer provide the following error terms:
Calibration type
Parameters in
[SENSe<Ch>:]CORRection:
COLLect:METHod:DEFine
Available error terms (depending on port num-
bers)
One-port normalization (reflection)
using an open or a short standard
REFL, RSHort
'REFLTRACK'
Full one port ("Refl OSM")
FOPort
'DIRECTIVITY', 'SRCMATCH', 'REFLTRACK'
Two-port normalization
FRTRans
'TRANSTRACK'
One path two port
OPTPort
'DIRECTIVITY', 'SRCMATCH', 'REFLTRACK',
'TRANSTRACK'
TOSM
TOSM
'DIRECTIVITY', 'SRCMATCH', 'REFLTRACK',
'LOADMATCH', 'TRANSTRACK'
VNA Command Reference
www.allice.de
Allice Messtechnik GmbH
