Rohde & Schwarz 1323.0012.03, User Manual

Page: 17 / 1014

Release Notes for Firmware V1.30
R&S
®
ZNL/ZNLE
17 User Manual 1178.5966.02 ─ 07
4 Release Notes for Firmware V1.30
4.1 Known Issues
The following table lists the known issues and indicates since which version the issue
could be observed:
since FW affected applications /
operating modes Function
V1.20 Spectrum Mode (R&S ZNL
hardware option B1)
In the ACLR measurement with Power Mode "Max Hold", if
the ACLR mode is changed between "lin" and "log" this set-
ting only works after the next sweep start (not during contin-
uous sweep).
Software version
► To check your R&S ZNL/ZNLE "Instrument Firmware" and "VNA Server" version,
select [SETUP] > "System Config" > "Ve Options".
4.2 Changes in Firmware V1.30
New Functionality
●
Spectrum analysis up to 6 GHz with hardware option R&S ZNL6-B1
●
100 kHz start frequency for R&S ZNLE with hardware option R&S ZNLE-B100
●
Time domain measurements for R&S ZNLE with software option R&S ZNL-K2
●
Distance to fault measurements for R&S ZNLE with software option R&S ZNL-K3
●
Translations of the analyzer GUI:
(preinstalled, no separate setup required)
–
German
– Spanish
– French
– Italian
– Japanese
– Korean
– Portuguese
– Russian
– Simplified Chinese (China)
– Traditional Chinese (Taiwan)
See Chapter 7.3.3, "Language Settings" , on page 132.
●
Offset calculation can be performed after deembedding/embedding calculation
Changes in Firmware V1.30
www.allice.de Allice Messtechnik GmbH