Rohde & Schwarz 1323.0012.03, User Manual

Page: 505 / 1014

Command Reference
R&S
®
ZNL/ZNLE
505 User Manual 1178.5966.02 ─ 07
10 Command Reference
The commands required to perform measurements in the VNA and Spectrum applica-
tions in a remote environment are described here.
It is assumed that the R&S ZNL/ZNLE has already been set up for remote operation in
a network as described in Chapter 7.4.5, "How to Set Up a Network and Remote Con-
trol" , on page 170.
● Conventions Used in SCPI Command Descriptions ............................................. 505
● Common Commands ............................................................................................ 506
● Common Instrument Commands .......................................................................... 510
● VNA Remote Control Basics .................................................................................561
● VNA Command Reference ....................................................................................580
● VNA Programming Examples ............................................................................... 936
10.1 Conventions Used in SCPI Command Descriptions
Note the following conventions used in the remote command descriptions:
●
Command usage
If not specified otherwise, commands can be used both for setting and for querying
parameters.
If a command can be used for setting or querying only, or if it initiates an event, the
usage is stated explicitly.
●
Parameter usage
If not specified otherwise, a parameter can be used to set a value and it is the
result of a query.
Parameters required only for setting are indicated as
Setting parameters .
Parameters required only to refine a query are indicated as Query parameters .
Parameters that are only returned as the result of a query are indicated as Return
values .
●
Conformity
Commands that are taken from the SCPI standard are indicated as SCPI con-
firmed . All commands used by the R&S ZNL/ZNLE follow the SCPI syntax rules.
●
Asynchronous commands
A command which does not automatically finish executing before the next com-
mand starts executing (overlapping command) is indicated as an
Asynchronous
command .
●
Reset values (*RST)
Default parameter values that are used directly after resetting the instrument (
*RST
command) are indicated as *RST values, if available.
●
Default unit
The default unit is used for numeric values if no other unit is provided with the
parameter.
Conventions Used in SCPI Command Descriptions
www.allice.de Allice Messtechnik GmbH