Rohde & Schwarz 1323.0012.03, User Manual

Page: 655 / 1014

Command Reference
R&S
®
ZNL/ZNLE
655 User Manual 1178.5966.02 ─ 07
Parameters:
<Enable> ON - Info fields are displayed for all traces, for which a limit
check is enabled.
OFF - Only the info field for the active trace is displayed (if the
ripple check is enabled for this trace).
*RST:
OFF
Manual operation: See "Show Results All Traces" on page 408
CALCulate:RIPPle:FAIL:ALL? [<ChannelSetup>]
Returns a 0 or 1 to indicate whether or not the global ripple limit check has failed for at
least one channel in the referenced channel setup.
Query parameters:
<ChannelSetup> Name of a VNA channel setup. Can be omitted if the active VNA
channel setup shall be referenced.
Usage: Query only
Manual operation: See "Ripple Check" on page 407
CALCulate<Chn>:RIPPle:CLEar
Resets the limit check results for the ripple test.
Suffix:
<Chn>
.
Channel number used to identify the active trace
Usage: Event
Manual operation: See "Clear Test" on page 408
CALCulate<Chn>:RIPPle:CONTrol:DOMain <SweepType>
Deletes the existing ripple limit ranges and (re-)defines the physical units of the stimu-
lus values of the ripple limit lines. The unit of the ripple limit is defined via
CALCulate<Chn>:RIPPle:RDOMain:FORMat
.
Suffix:
<Chn>
.
Channel number used to identify the active trace
Setting parameters:
<SweepType> FLIN | FLOG | FSEG | FSINgle | TLIN | TLOG
Keywords for the units of the stimulus values; frequency and
time units.
The selected unit must be compatible with the sweep type (see
[SENSe<Ch>:]SWEep:TYPE
on page 886): Hz for FLIN,
FLOG, FSEG and FSINgle, s for TLIN and TLOG. Otherwise the
ripple limit lines cannot be displayed and no ripple limit check is
possible.
*RST:
FLIN
VNA Command Reference
www.allice.de Allice Messtechnik GmbH