Command Reference
R&S
®
ZNL/ZNLE
651
User Manual 1178.5966.02 ─ 07
Parameters:
<ProbeTip>
Probe tip impedance
*RST:
0
Default unit: Ohm
Parameters for setting and query:
<TraceName>
Trace name
Manual operation:
See
CALCulate<Ch>:PARameter:SDEFine
<TraceName>, <Result>
Creates a trace and assigns a channel number, a name and a measurement parame-
ter to it. The trace becomes the active trace in the channel but is not displayed.
Note:
To display the trace defined via
CALCulate<Ch>:PARameter:SDEFine
, cre-
ON
) and assign the trace to this
diagram (
DISPlay[:WINDow<Wnd>]:TRACe<WndTr>:FEED
CALCulate<Ch>:PARameter:MEASure
changes the measurement result of an
existing trace.
To select an existing trace as the active trace, use
. You can open the trace manager to obtain an overview of all channels and
traces, including the traces that are not displayed.
Tip:
This command has no query form. Use
CALCulate<Ch>:PARameter:MEASure
'TraceName'
to query the measurement result of the trace.
returns a list of all defined traces.
Suffix:
<Ch>
.
Channel number. <Ch> may be used to reference a previously
defined channel. If <Ch> does not exist, it is generated with
default channel settings.
Setting parameters:
<TraceName>
Trace name, string variable, e.g. 'Trc4'. See "Rules for trace
names" in
on page 324. Trace names must be
unique across all channels and diagrams.
If a trace with the selected trace name already exists, the ana-
lyzer behaves as follows: If the existing trace is assigned to the
same channel as the new trace, it is deleted. The new trace is
not automatically assigned to a diagram area; see note above.
If the existing trace is assigned to a different channel, no new
trace can be created. The analyzer returns an error message.
<Result>
Measurement result (string variable), see table below.
VNA Command Reference
www.allice.de
Allice Messtechnik GmbH
