Getting Started
R&S
®
ZNL/ZNLE
47
User Manual 1178.5966.02 ─ 07
Function key
Assigned functions
VNA mode
SA mode
(R&S
ZNL only)
[Offset Embed]
Contains functions for deembedding/
embedding the DUT from/into physical/
virtual (matching) networks placed
between the calibrated reference plane
and the DUT.
Performs a peak search for active
marker. If no marker is active, normal
marker 1 is activated and the peak
search is performed for it.
[Meas]
Selects the quantities to be measured and displayed.
[Format]
[Config]
Selects the trace format (dB magnitude,
Smith, etc.).
Configure measurements and data input
and output
[Display Lines]
Configures display lines and limit lines.
[Cal]
[Single]
Provides all functions related to system
error calibration.
Starts and stops a single new measure-
ment (Single Sweep Mode)
[Channel]
[Cont]
Creates and deletes channel setups and
optimize the measurement process.
Starts and stops a continuous measure-
ment (Continuous Sweep Mode)
5.2.1.6
Keypad
The keypad is used to enter numeric parameters, including the corresponding units. It
contains the following keys:
Table 5-3: Keys on the keypad
Type of key
Description
Decimal point
Inserts a decimal point "." at the cursor position.
Sign key
Changes the sign of a numeric parameter. In the case of an alphanu-
meric parameter, inserts a "-" at the cursor position.
Unit keys
(G/n, M/
μ
, k/m, x1)
Adds the selected unit to the entered numeric value and complete the
entry.
In the case of level entries (e.g. in dB) or dimensionless values, all units
have the value "1" as multiplying factor. Thus, they have the same func-
tion as an [ENTER] key.
[ESC]
Closes all kinds of dialog boxes, if the edit mode is not active. Quits the
edit mode, if the edit mode is active. In dialog boxes that contain a "Can-
cel" button it activates that button.
For "Edit" dialog boxes the following mechanism is used:
●
If data entry has been started, it retains the original value and
closes the dialog box.
●
If data entry has not been started or has been completed, it closes
the dialog box.
Instrument Tour
www.allice.de
Allice Messtechnik GmbH
