VNA GUI Reference
R&S
®
ZNL/ZNLE
492
User Manual 1178.5966.02 ─ 07
shift of a transmission parameter. See also
Chapter 8.6.1.6, "Application and Effect of
Remote command:
[SENSe<Ch>:]CORRection:LOSS<PhyPt>:OFFSet
[SENSe<Ch>:]CORRection:LOSS<PhyPt>
[SENSe<Ch>:]CORRection:LOSS<PhyPt>:FREQuency
Auto Length and Loss
Determines all offset parameters such that the residual group delay of the active trace
(defined as the negative derivative of the phase response) is minimized and the mea-
sured loss is minimized as far as possible across the entire sweep range.
Chapter 8.6.1.4, "Auto Length and Loss"
Note:
If "Auto Length and Loss" is used with a line connected to a test port, the end of
the line should be left open.
Remote command:
[SENSe<Ch>:]CORRection:LOSS<PhyPt>:AUTO
9.14.4
Single Ended Tab
Allows you to specify 2-port deembedding/embedding networks for each physical port.
Such a network is either defined:
●
via its S-parameters stored in a two-port Touchstone file (
*.s2p
) or
●
by selecting a predefined lumped element model and specifying the available
parameters (resistances/conductances, capacitances, inductances)
Chapter 8.6.2.3, "Circuit Models for 2-Port Networks"
Use the complementary dock widget to activate or deactivate dembedding/embedding
for selected ports (see
Chapter 9.14.1.3, "Single Ended Panel"
Background information
Refer to the section
Chapter 8.6.2.9, "Combining Several De-/Embedding Networks"
Offset Embed Softtool
www.allice.de
Allice Messtechnik GmbH
