VNA GUI Reference
R&S
®
ZNL/ZNLE
411
User Manual 1178.5966.02 ─ 07
Show Limit Circle
Shows or hides the limit line associated with the active trace in a polar diagram area.
Note:
Display of the limit line and limit check are independent of each other: Hiding the
limit line does not switch off the limit check.
Remote command:
CALCulate<Chn>:LIMit:CIRCle:DISPlay[:STATe]
Limit Check
Switches the limit check of the active trace on or off.
When the limit check is switched on, a movable "PASS" or "FAIL" message is dis-
played in the diagram. If the limit check fails at a measurement point, the point is
marked with a colored square. An acoustic signal (
indicating pass or fail can be generated in addition.
Display Lines Softtool
www.allice.de
Allice Messtechnik GmbH
