Common Instrument Functions
R&S
®
ZNL/ZNLE
123
User Manual 1178.5966.02 ─ 07
The R&S
ZNL/ZNLE can use the internal reference source or an external reference
source as the frequency standard for all internal oscillators. A 10
MHz crystal oscillator
is used as the internal reference source. In the external reference setting, all internal
oscillators of the R&S
ZNL/ZNLE are synchronized to the external reference frequency.
External references are connected to one of the [REF INPUT] connectors on the rear
panel. For details see the R&S
ZNL/ZNLE "Getting Started" manual.
The default setting is the internal reference. When an external reference is used, "EXT
REF" is displayed in the status bar.
OCXO Option
The OCXO (R&S
FPL1-B4) option generates a 10
MHz reference signal with a very
precise frequency. If installed, and if no external signal is used, this signal is used as
an internal reference. It can also be used to synchronize other connected devices via
the Ref. Out 10
MHz connector.
This option is not available for the R&S
ZNLE
When the instrument is switched on, the OCXO requires an extended warm-up time
(see data sheet).
Remote command:
7.3.2
Display Settings
7.3.2.1
Display Settings
Access
: [Setup] > "Display"
Some general display settings are available regardless of the current application or
operating mode. For information on optimizing your display for measurement results,
see the application-specific result configuration descriptions.
.......................................................................................123
....................................................................................128
......................................................................................130
General Display Settings
Access
: [Setup] > "Display" > "General"
This section includes general screen display behavior and date and time display.
General Instrument Setup
www.allice.de
Allice Messtechnik GmbH
