VNA GUI Reference
R&S
®
ZNL/ZNLE
476
User Manual 1178.5966.02 ─ 07
●
1 enables the output signal at pin 8. The signal is switched on while a measure-
ment sweep is running in the selected channel. All other signals are inactive.
●
2 enables the output signal at pin 9.
●
3 enables the output signals at pins 8 and 9.
●
...
●
255 enables the output signals at all pins. See also
Remote command:
Pin 16 - 19
Selects the control mechanism for the signals at pins 16 to 19 of the Aux. Port connec-
tor.
●
"Channel Bits":
Signals are controlled by channel bits 4 to 7. No drive port indica-
tion at the Aux. Port connector.
●
"Drive Ports":
Signals indicate the active drive ports. The number of active chan-
nel bits is reduced to 4 (pins 8 to 11).
Remote command:
9.14
Offset Embed Softtool
The "Offset Embed" softtool allows you to define a length offset and loss for each test
port. The offset compensates for the known length and loss of (non-dispersive and per-
fectly matched) transmission lines between the calibrated reference plane and the
DUT. It also contains advanced functions for deembedding/embedding the DUT from/
into more general physical/virtual (matching) networks placed between the calibrated
reference plane and the DUT.
Access:
[Offset
Embed]
Background information
Refer to
Chapter 8.6, "Offset Parameters and Embedding"
9.14.1
Offset Embed Dock Widget
On activating a tab in the "Offset Embed" softtool, a dock widget is displayed beneath
the trace area, whose content pane is synchronized with the selected softtool tab.
Access:
[Offset
Embed]
9.14.1.1
Overview Panel
Shows an overview of the overall calculation flow and provides quick access to the
"Offset Embed" functions.
Access:
[Offset
Embed] > "Overview"
Offset Embed Softtool
www.allice.de
Allice Messtechnik GmbH
