Raritan PX3-3000 series, Руководство пользователя

Страница: 275 / 875

Chapter 6: Using the Web Interface
251
Configuring Network Settings
Configure wired, wireless, and Internet protocol-related settings on the
Network page after
connecting the PX3 to your network
(on page 23).
You can enable both the wired and wireless networking on the PX3 so
that it has multiple IP addresses -- wired and wireless IP. For example,
you can obtain one IPv4 and/or IPv6 address by enabling one Ethernet
interface, and obtain one more IPv4 and/or IPv6 address by
enabling/configuring the wireless interface. This also applies when the
PX3 enters the port forwarding mode so that the PX3 has more than one
IPv4 or IPv6 address in the port forwarding mode.
However, the PX3 in the BRIDGING mode obtains "only one" IP address
for wired networking. Wireless networking is NOT supported in this
mode.
Important: In the bridging mode, only the IP parameters of the
BRIDGE interface function. The IP parameters of the ETHERNET (or
ETH1/ETH2) and WIRELESS interfaces do NOT function.
To set up the network settings:
1. Choose Device Settings > Network.
2. To use DHCP-assigned DNS servers and gateway instead of static
ones, go to step 3. To manually specify DNS servers and default
gateway, configure the Common Network Settings section. See
Common Network Settings (on page 253).

Static routes and cascading mode are in this section. You need to
configure them only when there are such local requirements.
See
Setting the Cascading Mode (on page 265) and Static
Route Examples (on page 260).
3. To configure IPv4/IPv6 settings for a
wired network, click the
ETHERNET (or ETH1/ETH2) or BRIDGE section. See Wired Network
Settings (on page 252).

If the device's cascading mode is set to 'Bridging', the BRIDGE
section appears. Then you must click the BRIDGE section for
IPv4/IPv6 settings.
4. To configure IPv4/IPv6 settings for a
wireless network, click the
WIRELESS section. See Wireless Network Settings (on page 255).

You must connect a USB wireless LAN adapter to the PX3 for
wireless networking.
Note: If the device's cascading mode is set to 'Bridging' or its role is
set to 'Slave' in the port forwarding mode, the wireless settings will
be disabled.