Raritan PX3-3000 series, Руководство пользователя

Страница: 524 / 875

Chapter 8: Using the Command Line Interface
500
Interface Description
eth2
(PX3-iX7)
Determine the IPv6 preferred host name of the
ETH2 interface (wired networking).
wireless Determine the IPv6 preferred host name of the
WIRELESS interface (that is, wireless
networking).
bridge Determine the IPv6 preferred host name of the
BRIDGE interface (that is, bridging mode).

<name> is a host name which:

Consists of alphanumeric characters and/or hyphens

Cannot begin or end with a hyphen

Cannot contain more than 63 characters

Cannot contain punctuation marks, spaces, and other symbols
Setting the IPv6 Address
After selecting the static IP configuration mode, you can use this
command to assign a permanent IP address to the PX3 device.
config:# network ipv6 interface <ETH> address <ip
address>
Variables:

<ETH> is one of the network interfaces:
ethernet (or ETH1/ETH2),
wireless, or bridge. Note that you must choose/configure the bridge
interface if your PX3 is set to the bridging mode.
Note: In the bridging mode, only the IP parameters of the BRIDGE
interface function. The IP parameters of the ETHERNET (or
ETH1/ETH2) and WIRELESS interfaces do NOT function.
Interface Description
ethernet (PX3) Determine the IPv6 address of the ETHERNET
interface (that is, wired networking).
eth1
(PX3-iX7)
Determine the IPv6 address of the ETH1 interface
(wired networking).
eth2
(PX3-iX7)
Determine the IPv6 address of the ETH2 interface
(wired networking).