Dell C9000 series, Reference Manual

Page: 2279 / 2286

• vlan-stack protocol-type
• vlan-stack trunk
member
Assign a stackable VLAN access or trunk port to a VLAN. The VLAN must contain the
vlan-stack
compatible
command in its configuration.
C9000 Series
Syntax
member interface
To remove an interface from a Stackable VLAN, use the
no member interface
command.
Parameters
interface Enter the following keywords and slot/port or number
information:
• For a Port Channel interface, enter the keywords
port-
channel
then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
then the slot/ port information.
Defaults Not configured.
Command Modes CONF-IF-VLAN
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.11.1 Introduced on the Z9000.
8.2.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the C-Series and S-Series.
Usage Information You must enable the stackable VLAN (using the
vlan-stack compatible
command)
on the VLAN prior to adding a member to the VLAN.
VLAN Stacking 2279