Dell C9000 series, Reference Manual

Page: 2084 / 2286

Version Description
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
Usage Information Syslog messages contain the IP address of the interface used to egress the router. By
configuring the
logging source-interface
command, the Syslog packets contain
the IP address of the interface configured.
Related
Commands
logging — enables logging to the Syslog server.
logging synchronous
Synchronize unsolicited messages and output.
C9000 Series
Syntax
logging synchronous [level level | all] [limit number-of-buffers ]
To disable message synchronization, use the
no logging synchronous [level
level | all] [limit number-of-buffers ]
command.
Parameters
all Enter the keyword
all
to ensure that all levels are printed
asynchronously.
level level Enter the keyword
level
then a number as the severity level. A
high number indicates a low severity level and vice versa. The
range is from 0 to 7. The default is
2 .
all Enter the keyword
all
to turn off all.
limit number-of-
buffers
Enter the keyword
limit
then the number of buffers to be
queued for the terminal after which new messages are dropped.
The range is from 20 to 300. The default is
20 .
Defaults Disabled. If enabled without the
level
or
number-of-buffers
options specified,
level = 2 and number-of-buffers = 20 are the defaults.
Command Modes LINE
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Simple Network Management Protocol (SNMP) and Syslog 2084