Dell C9000 series, Reference Manual

Page: 1127 / 2286

Usage Information IGMP commands accept only non-VLAN interfaces — specifying VLAN does not yield
results. This command displays packets for IGMP and IGMP snooping.
ip igmp access-group
Specify access control list for packets in access-group.
C9000 Series
Syntax
ip igmp access-group access-list
To remove the feature, use the
no ip igmp access-group access-list
command.
Parameters
access-list Enter the name of the extended ACL (16 characters maximum).
Defaults Not configured
Command Modes INTERFACE (conf-if- interface-slot/port )
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.5(0.1) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the C-Series and S-Series.
7.6.1.0 Introduced on the E-Series.
Usage Information The access list accepted is an extended ACL. The
ip igmp access-group
command
allows you to block IGMP reports from hosts, on a per-interface basis based on the
group address and source address that you specify in the access list.
Internet Group Management Protocol (IGMP) 1127