Service Provider Bridging
Service provider bridging is composed of virtual local area network (VLAN) Stacking, Layer 2 Protocol
Tunneling, and Provider Backbone Bridging as described in the
Dell Networking OS Configuration Guide
Service Provider Bridging
chapter.
This chapter includes command line information (CLI) for the Dell Networking operating software Layer 2
Protocol Tunneling (L2PT). L2PT enables protocols to tunnel through an 802.1q tunnel.
For more information, refer to
, and
.
Important Points to Remember
• L2PT is enabled at the interface VLAN-Stack VLAN level. For more information about Stackable VLAN
(VLAN-Stacking) commands, refer to
.
• The default behavior is to disable protocol packet tunneling through the 802.1q tunnel.
• Rate-limiting is required to protect against bridge protocol data units (BPDU) attacks.
• A port channel (including through link aggregation control protocol [LACP]) can be configured as a
VLAN-Stack access or trunk port.
• Address resolution protocol (ARP) packets work as expected across the tunnel.
• Far-end failure detection (FEFD) works the same as with Layer 2 links.
• Protocols that use Multicast MAC addresses (for example, open shortest path first [OSPF]) work as
expected and carry over to the other end of the VLAN-Stack VLAN.
Topics:
•
•
•
protocol-tunnel destination-mac
•
•
•
52
Service Provider Bridging
2016
Summary of Contents for C9000 series
Page 1: ...Dell Networking Command Line Reference Guide for the C9000 Series Version 9 10 0 0 ...
Page 394: ...deny 14551 666 Dell Access Control Lists ACL 394 ...
Page 877: ...algorithm FIPS Cryptography 877 ...
Page 1297: ...Total 5 0 Total 5 active route s using 952 bytes IPv6 Basics 1297 ...
