Dell C9000 series, Reference Manual

Page: 605 / 2286

percentage of the maximum value, the software sends a
message. The range is 1 to 100 percent. The default is
75 .
warning-only (OPTIONAL) Enter the keywords
warning-only
to set the
router to send a log message when the maximum value is
reached. If you do not set this parameter, the router stops
peering when the maximum number of prefixes is reached.
Defaults
threshold
= 75
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command History
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.2.1.0 Introduced on the E-Series ExaScale.
7.4.1.0 Introduced
Usage Information If you configure the
neighbor maximum-prefix
command and the neighbor
receives more prefixes than allowed by the
neighbor maximum-prefix
command
configuration, the neighbor goes down and the
show ip bgp summary
command
displays ( prfxd ) in the State/PfxRcd column for that neighbor. The neighbor remains
down until you enter the
clear ip bgp
command for the neighbor or the peer group
to which the neighbor belongs or you enter the
neighbor shutdown
and
neighbor
no shutdown
commands.
Related
Commands show ip bgp summary – displays the current BGP configuration.
neighbor next-hop-self
Allows you to configure the router as the next hop for a BGP neighbor. (This command is used for IBGP).
C9000 Series
Syntax
neighbor { ipv6-address | peer-group-name } next-hop-self
To return to the default setting, use the
no neighbor { ipv6-address | peer-
group-name } next-hop-self
command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
peer-group-name (OPTIONAL) Enter the name of the peer group.
Border Gateway Protocol 605