Dell C9000 series, Reference Manual

Page: 473 / 2286

Version Description
7.7.1.0 Introduced on the C-Series.
Usage Information To enter AS-PATH ACL mode and configure the AS-PATH filters to deny or permit BGP
routes based on information in their AS-PATH attribute, use the
ip as-path access-
list
command in CONFIGURATION mode.
Related
Commands ip as-path access-list — enter AS-PATH ACL mode and configure the AS-PATH filters.
neighbor graceful-restart
Enable graceful restart on a BGP neighbor.
C9000 Series
Syntax
neighbor { ip-address | peer-group-name } graceful-restart [restart-
time seconds ] [stale-path-time seconds ] [role receiver-only]
To return to the default, enter the
no bgp graceful-restart
command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group to apply the filter to all routers
in the peer group.
restart-time
seconds
Enter the keyword
restart-time
then the maximum number
of seconds to restart and bring-up all the peers. The range is
from 1 to 3600 seconds. The default is
120 seconds .
stale-path-time
seconds
Enter the keyword
stale-path-time
then the maximum
number of seconds to wait before restarting a peer’s stale paths.
The default is
360 seconds .
role receiver-only Enter the keyword
role receiver-only
to designate the
local router to support graceful restart as a receiver only.
Defaults as above
Command Modes ROUTER BGP
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
Border Gateway Protocol 473