Dell C9000 series, Reference Manual

Page: 2033 / 2286

Parameters
interval value Enter the interval value in seconds. The range is from 15 to
86400 seconds. The default is
20 seconds .
Defaults 20 seconds
Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Introduced the Configuration Terminal Batch mode on C9010.
9.9(0.0) Introduced on the C9010.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on S-Series Stacking.
8.1.1.0 Introduced on the E-Series ExaScale.
7.7.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
Usage Information The polling interval for an interface is the maximum number of seconds between
successive samples of counters sent to the collector. This command changes the
global default counter polling (20 seconds) interval. You can configure an interface to
use a different polling interval.
Use this command in Configuration Terminal Batch mode to set the sFlow polling
interval in a dual-homing setup.
Related
Commands sflow polling-interval (Interface) — sets the polling interval for an interface.
sFlow 2033