Dell C9000 series, Reference Manual

Page: 916 / 2286

•
grep
— show only text that matches a pattern.
•
no-more
— do not paginate the output.
•
save
— save the output to a file.
The following describes the
show redundancy
command shown in the following
example.
Field Description
RPM Status Displays the following information:
• Slot number of the RPM.
• Whether the RPM is Primary or Standby.
• The state of the RPM: Active, Standby, Booting, or Offline.
• Whether the link to the second RPM is up or down.
PEER RPM Status Displays the state of the second RPM, if present
RPM Redundancy
Configuration Displays the following information:
• which RPM is the preferred Primary on next boot (the
redundancy primary
command)
• the data sync method configured (the
redundancy
synchronize
command)
• the failover type (you cannot change this type; it is
software-dependent). Hot Failover means that the running
configuration and routing table are applied on secondary
RPM. Fast Failover means that the running configuration is
not applied on the secondary RPM until failover occurs,
and the routing table on line cards is cleared during
failover.
• the status of auto booting the RPM (the
redundancy
disable-auto-reboot
command)
• the parameter for auto failover limit control (the
redundancy auto-failover-limit
command)
RPM Failover
Record Displays the following information:
• RPM failover counter (to reset the counter, use the
redundancy reset-counter
command)
• the time and date of the last RPM failover
• the reason for the last RPM failover
Last Data Sync
Record Displays the data sync information and the timestamp for the
data sync:
• Start-up Config is the contents of the startup-config file.
• Line Card Config is the line card types configured and
interfaces on those line cards.
• Runtime Event Log is the contents of the Event log.
• Running Config is the current running-config.
High Availability (HA) 916