Dell C9000 series, Reference Manual

Page: 1588 / 2286

key-encryption-
type
(OPTIONAL) Specifies if the authentication key is encrypted.
Valid values: 0 (key is not encrypted) or 7 (key is encrypted).
key
Text string used in authentication.
For MD5 authentication, the key must be 32 hex digits (non-
encrypted) or 64 hex digits (encrypted).
For SHA-1 authentication, the key must be 40 hex digits (non-
encrypted) or 80 hex digits (encrypted).
Defaults Not configured.
Command Modes INTERFACE
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
9.1.(0.0) Introduced on the S4810 and Z9000.
8.4.2.0 Introduced on the E-Series TeraScale.
8.3.19.0 Introduced on the S4820T.
Usage Information Before you enable IPsec encryption on an OSPFv3 interface, first enable IPv6 unicast
routing globally, configure an IPv6 address and enable OSPFv3 on the interface, and
assign the interface to an area.
An SPI value must be unique to one IPsec security policy (authentication or encryption)
on the router. Configure the same encryption policy (same SPI and key) on each
OSPFv3 interface in a link.
To remove an IPsec encryption policy from an interface, enter the
no ipv6 ospf
encryption spi number
command. To remove null authentication on an interface
to allow the interface to inherit the authentication policy configured for the OSPFv3
area, enter the
no ipv6 ospf no ipv6 ospf encryption null
command.
Related
Commands
area encryption – configures an IPsec encryption policy for an OSPFv3 area.
show crypto ipsec policy – displays the configuration of IPsec encryption policies.
Open Shortest Path First (OSPFv2 and OSPFv3) 1588