Dell C9000 series, Reference Manual

Page: 697 / 2286

Version Description
9.9(0.0) Introduced on the C9010.
9.7(0.1) Introduced on the S3048-ON and S4048-ON .
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information By default, iSCSI is enabled on the unit and the flow control is enabled on all of the
interfaces. It is also acts as defaults when the link-level flow control is enabled on one
or more interfaces.
To enable DCB, do one of the following:
• Apply the
dcb-input policy
command with the
no pfc-mode
command on
to all the interfaces.
• Disable flow-control on all of the interfaces.
Enables priority flow control or enhance transmission selection on interface.
Related
Commands dcb <ets | pfc> enable — enable priority flow control or enhanced transmission
selection on interface.
dcb-output
To associate an ETS configuration with priority traffic, create a DCB output policy.
C9000 Series
Syntax
dcb-output policy-name
To remove the ETS output policy globally, use the
no dcb output policy-name
command.
Parameters
policy-name Enter the DCB output policy name. The maximum is 32
alphanumeric characters.
Defaults none
Command Modes CONFIGURATION
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide .
Data Center Bridging (DCB) 697