Dell C9000 series, Reference Manual

Page: 811 / 2286

Version Description
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the C-Series and S-Series.
ip address dhcp
Configure an interface to receive its IP address from the configured DHCP server.
C9000 Series
Syntax
ip address dhcp
To release the IP address acquired from a DHCP server, enter the
no ip address
dhcp
command.
Defaults Not configured.
Command Modes INTERFACE
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
Usage Information You must be in INTERFACE mode in order to configure an interface to dynamically
acquire an IP address from a DHCP server.
Use the
no ip address dhcp
in INTERFACE mode to:
• Release the IP address that was dynamically acquired from a DHCP server from
the interface.
Dynamic Host Configuration Protocol (DHCP) 811