Dell C9000 series, Reference Manual

Page: 101 / 2286

• For VLAN interface, enter the keyword
vlan
then a
number from 1 to 4094.
• For a tunnel interface, enter the keyword
tunnel
.
Defaults The IP address on the system that is closest to the Telnet address is used in the
outgoing packets.
Command Modes CONFIGURATION
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.2.1.0 Increased number of VLANs on ExaScale to 4094 (was 2094).
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series Original command
Related
Commands telnet — telnets to another device.
ip tftp source-interface
Assign an interface’s IP address in outgoing packets for TFTP traffic.
C9000 Series
Syntax
ip tftp source-interface interface
Control and Monitoring 101