power-cycle
Power-cycle the port extender (PE) stack-unit from the PE console
C9000 Series
Syntax
power-cycle stack-unit {
unit-number
| all }
Parameters
unit-number
Enter a stack-unit number. Range is from 0 to 7.
all
Enter
all
to power-cycle all the stack-units.
Command Modes
EXEC
Command History This guide is platform-specific. For command information about other platforms, see
the relevant
Dell Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.9(0.0)
Introduced on the C9010 and C1048P.
Usage Information
CAUTION:
Do not attempt to reset or power cycle when the system is going
through the process of upgrading.
Example
Dell#power-cycle ?
stack-unit Stack-unit
Dell#power-cycle stack-unit ?
<0-7> Unit number
all Entire stack
Dell#power-cycle stack-unit 0
Dell#power-cycle stack-unit all ?
PE Console Commands
1617
Summary of Contents for C9000 series
Page 1: ...Dell Networking Command Line Reference Guide for the C9000 Series Version 9 10 0 0 ...
Page 394: ...deny 14551 666 Dell Access Control Lists ACL 394 ...
Page 877: ...algorithm FIPS Cryptography 877 ...
Page 1297: ...Total 5 0 Total 5 active route s using 952 bytes IPv6 Basics 1297 ...
