Parameters
subnet-number
Enter a subnet number in dotted decimal format (A.B.C.D.) as
the allowable range of addresses included in the Peer group.
To allow all addresses, enter
0.0.0.0/0
.
mask
Enter a prefix mask in / prefix-length format (/x).
Defaults
Not configured.
Command Modes
ROUTER BGP
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant
Dell Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.9(0.0)
Introduced on the C9010.
9.2(1.0)
Introduced on the Z9500.
8.3.11.1
Introduced on the Z9000.
7.8.1.0
Introduced on the S-Series.
7.7.1.0
Introduced on the C-Series.
neighbor timers
Set keepalive and hold time timers for a BGP neighbor or a peer group.
C9000 Series
Syntax
neighbor {
ip-address
|
peer-group-name
} timers
keepalive holdtime
To return to the default values, use the
no neighbor {
ip-address
|
peer-
group-name
} timers
command.
Parameters
ip-address
Enter the IP address of the peer router in dotted decimal format.
peer-group-name
Enter the name of the peer group to set the timers for all routers
within the peer group.
keepalive
Enter a number for the time interval, in seconds, between
keepalive messages sent to the neighbor routers. The range is
from 1 to 65535. The default is
60 seconds
.
Border Gateway Protocol
490
Summary of Contents for C9000 series
Page 1: ...Dell Networking Command Line Reference Guide for the C9000 Series Version 9 10 0 0 ...
Page 394: ...deny 14551 666 Dell Access Control Lists ACL 394 ...
Page 877: ...algorithm FIPS Cryptography 877 ...
Page 1297: ...Total 5 0 Total 5 active route s using 952 bytes IPv6 Basics 1297 ...
