Dell C9000 series, Reference Manual

Page: 1566 / 2286

To return to the default, use the
no timers throttle lsa
command.
Parameters
arrival-time Set the interval between receiving the same LSA repeatedly, to
allow sufficient time for the system to accept the LSA. The range
is from 0 to 600,000 milliseconds.
Defaults 1000 msec
Command Modes ROUTER OSPF
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.8.0 Introduced on the S4810.
OSPFv3 Commands
The fundamental mechanisms of OSPF (flooding, DR election, area support, SPF calculations, and so on)
remain unchanged. However, OSPFv3 runs on a per-link basis instead of on a per-IP-subnet basis. Most
changes were necessary to handle the increased address size of IPv6.
The Dell Networking implementation of OSPFv3 is based on IETF RFC 2740.
area authentication
Configure an IPsec authentication policy for OSPFv3 packets in an OFSPFv3 area.
C9000 Series
Syntax
area area-id authentication ipsec spi number {MD5 | SHA1} [key-
encryption-type] key
Parameters
area area-id
Area for which OSPFv3 traffic is to be authenticated. For area-id,
you can enter a number.
Open Shortest Path First (OSPFv2 and OSPFv3) 1566