Dell C9000 series, Reference Manual

Page: 360 / 2286

ip prefix-list test4:
count: 1, range entries: 1, sequences: 5 - 5
ip prefix-list test5:
count: 1, range entries: 1, sequences: 5 - 5
ip prefix-list test6:
count: 1, range entries: 1, sequences: 5 - 5
Dell#
Route Map Commands
When you create an access-list without any rule and then apply the list to an interface, the ACL behavior
reflects implicit permit.
To configure route maps and their redistribution criteria, use the following commands.
continue
To a route-map entry with a higher sequence number, configure a route-map.
C9000 Series
Syntax continue [ sequence-number ]
Parameters
sequence-
number (OPTIONAL) Enter the route map sequence number. The range
is from 1 to 65535.
Defaults Not configured.
Command Modes ROUTE-MAP
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
Access Control Lists (ACL) 360