Dell C9000 series, Reference Manual

Page: 546 / 2286

Version Description
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information
CAUTION: Dell Networking recommends not changing the administrative
distance of internal routes. Changing the administrative distances may cause
routing table inconsistencies.
The higher the administrative distance assigned to a route means that your confidence
in that route is low. Routes assigned an administrative distance of 255 are not installed
in the routing table. Routes from confederations are treated as internal BGP routes.
Related
Commands
router bgp — enters ROUTER mode on the switch.
show ip bgp dampened-paths
View BGP routes that are dampened (non-active).
C9000 Series
Syntax
show ip bgp [vrf vrf-name ] [ipv4 { multicast | unicast } | ipv6
unicast ] dampened-paths
Parameters
vrf vrf-name (OPTIONAL) Enter the keywords
vrf
and then the name of the
VRF to view routes that are affected by a specific community list
corresponding to that VRF.
ipv4 multicast (OPTIONAL) Enter the keyword
ipv4
followed by the keyword
multicast
to view information related only to ipv4 multicast
routes.
ipv4 unicast (OPTIONAL) Enter the keywords
ipv4
followed by the keyword
unicast
to view information related only to ipv4 unicast routes.
ipv6 unicast (OPTIONAL) Enter the keyword
ipv6
followed by the keyword
unicast
to view information related only to ipv6 unicast routes.
Command Modes
• EXEC
• EXEC Privilege
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Border Gateway Protocol 546